The MultiBonnet® is designed to allow quick and easy repair of bonnet packing in MultiValves® and Service Valves on active propane systems. It eliminates the need to evacuate tanks or cylinders to repair the MultiBonnet® packing. The two section design allows repair on MultiBonnets® assembly without any interruption in gas service.

The following illustrates the repair of a MultiBonnet® in a Rego® MultiValve® or Service Valve that is on an active pressurized propane system. It is important that when actual repairs are conducted, the individual doing the repairs be completely familiar with and follow the 19104-800 instruction sheet included with the 19104-80 repair kit. These instructions MUST be followed. ONLY qualified personnel should attempt installation of the MultiBonnet® repair kit. Follow all federal, provincial, state, and local regulations.

1. Turn hand wheel counter-clockwise as far as possible to assure valve is completely open and back seated.
   
   
2. Remove self tapping screw and hand wheel.
   
   
3. Holding the lower section of the MultiBonnet® in place with a wrench, use a second wrench to remove the upper bonnet packing assembly.
   
4. Thread the new upper bonnet packing assembly into the lower section of the MultiBonnet®.
   
   
5. Tighten upper packing assembly with 50 to 75 inch/lbs. torque.
   
   
6. Reassemble the hand wheel and check for valve leaks.